For Tomasz Chmielewski I was successfully run my asus wl-500Gp with pppoe via wan port. Configuration on your site is correctly but is not exhaustively. When we use this configuration robocfg switch disable robocfg vlans enable reset robocfg vlan 0 ports "0 1 2 3 4 5u" robocfg switch enable we have only 5 ports switch. When we need router with 4 ports switch and 1 wan port. We should config robo switch like that: robocfg switch disable robocfg vlans enable reset robocfg vlan 0 ports "0 5u" robocfg vlan 1 ports "1 2 3 4 5t" robocfg switch enable and next add new lan interface vconfig add eth0 1 Witch this configuration we have 3 interfaces eth0 it is correct wan interface. They listen on WAN port. eth0.1 it is correct lan interface. The listen on 4 lan ports. eth1 probably it is only virtual interface but I'm not sure. On my asus wl-500Gp this configuration works fine. Small documentation of robocfg is placed hare http://wiki.openwrt.org/OpenWrtRoboCfg I don't know we we use "1 2 3 4 5t" with 5t not 5u but they is working only with 5t. Probably 5t is eth1 on debian. Please add this information on your site. If you want I can rent you my usb modem thomson speedtouch 330. Thanks for help and suggestions. |