Don't forget some people on polish forums give advice how reactivate asus box. You should read about connect pin9 to ground. You should read this http://openlinksys.info/forum/viewthread.php?forum_id=27&thread_id=3514 Dnia 25-02-2008, Pn o godzinie 23:51 +0100, Tomasz Orłowski pisze: > > Tomasz Orłowski napisał(a): > > no risk no fun :) > > So I'm beginning..... :) > > > > Thanks mate. > > > > > > > > Shit, and I've bricked my box :'( > It was so close to success :'( > When I've compared our nvram settings there were only 3 differences: > > hardware_version=WL500gp-01-02-00-00 > hardware_version=WL500gH-01-00-00-00 > > pmon_ver=CFE 3.91.23.0 > pmon_ver=CFE 3.91.7.0 > > sdram_ncdl=0x10309 > sdram_ncdl=0x10407 > > So off course I was trying to play with sdram_ncdl > I set it first to 0x10407 as you have - without results > Then to 0 as its recommended in many posts - without results > I became nervous and changed sdram_init from 0x0009 to 0x000b as it was > recommended in many posts too > And it helped! No segmentation faults and bus errors after this trick > but memory had been reduced to 16 MB > > I 've became really mad and started desperate tricks from > http://wl500g.dyndns.org/sdram.html > and finaly sdram_init=0x000a killed my box > > Now I don't see anything from serial console :'( Typical result of being > greedy and stupid. It was so close...... > > RIP > > > > ------------------------------------------------------------------------- > Easy Software Deployment >> http://wpkg.org > _______________________________________________ > debian-non-standard mailing lists > debian-non-standard at lists.wpkg.org > http://lists.wpkg.org/mailman/listinfo/debian-non-standard |