Finn Herpich schrieb: > hello everyone, > > i finally got my wl500gP up and running with a big smile on my face. > > so, i've tried to configure an additional vlan but i can't figure it out how > to do it correctly. > > i've one network on port 1 and the other on port 4. to do this i changed my > startup-script from > > robocfg switch disable > robocfg vlans enable reset > robocfg vlan 0 ports "0 5u" > robocfg vlan 1 ports "1 2 3 4 5t" > robocfg switch enable > > to > > robocfg switch disable > robocfg vlans enable reset > robocfg vlan 0 ports "0 5u" > robocfg vlan 2 ports "1 5t" vlan 1 ports "2 3 4 5t" > vconfig add eth0 2 > robocfg switch enable > > and thought this would do it, but robocfg show still gives me > > Switch: enabled > Port 0(W): DOWN enabled stp: none vlan: 1 mac: 00:00:00:00:00:00 > Port 1(4): 100FD enabled stp: none vlan: 0 mac: 00:00:00:00:00:00 > Port 2(3): DOWN enabled stp: none vlan: 0 mac: 00:00:00:00:00:00 > Port 3(2): DOWN enabled stp: none vlan: 0 mac: 00:00:00:00:00:00 > Port 4(1): 100FD enabled stp: none vlan: 0 mac: 00:00:00:00:00:00 > Port 5(C): 100FD enabled stp: none vlan: 0 mac: 00:00:00:00:00:00 > VLANs: BCM5325/535x enabled mac_check mac_hash > vlan0: 1 2 3 4 5u > vlan1: 0 5u > vlan2: > > i suggest the error is in the startup-script. > > any ideas how to do this correctly? need more informations? Did you read this one: http://wpkg.org/Running_Debian_on_ASUS_WL-500G_deluxe#More_detailed_robocfg.2Fvlan_settings and a link to openwrt wiki which can be found in that post? -- Tomasz Chmielewski |