Pete, I was able to setup stgt with iSER support. However, when I try to run a simple sgp_dd (or dd) command, I get SCSI errors on the initiator side: writing blk=256: Host_status=0x02 [DID_BUS_BUSY] error finishing sg out command If I connect to the target over TCP, everything works ok. Also, if I connect to our iSCSI over iSER target (not stgt), it also works ok with iSER. Is there any required patch for iSER/open-iscsi on the initiator side? Is there any debug info that I can see on the target side? -- ____________________________________________________________ Erez Zilber | 972-9-971-7689 Software Engineer, Storage Team Voltaire ? _The Grid Backbone_ __ www.voltaire.com <http://www.voltaire.com/> |