Hi Charles, If you are just using CentOS as the initiator and not the target then you could always use iscsi-initiator-utils (a.k.a. open-iscsi) instead of ofed. This is supported in the official CentOS repos. You just need to yum install iscsi-initiator-utils iscsiadm -m discovery -p <targetip> -t sendtargets iscsiadm -m node -p <targetip> -T <target iqn reported by prev cmd> -l Then the block device nodes appear - as if by magic - under /dev/disk/by-path/ I'm not familiar with ofed, but it sounds like it requires you to reconfigure and rebuild your kernel. Regards, Alex charles zhuang wrote: > Hi, > I am using centos 5.3 (kernel 2.6.18) + ofed 1.4 as my initiator, when I > try to login on iscsi target, there's following errors in the initiator > side: > iscsi: registered transport (tcp) > scsi5 : iSCSI Initiator over TCP/IP > connection4:0: Could not create connection due to crc32c loading error. > Make sure the crc32c module is built as a module or into the kernel > session4: couldn't create a new connection.<6>scsi6 : iSCSI Initiator > over TCP/IP > > I am able to run thru the same procedure on ubuntu 8.04 (kernel 2.6.24). > > There's no crc32c.ko and libcrc32c.ko under /lib/modules. > Any ideas on how can I get it run on my current centos 5.3 box? > Thanks for your help. > > Thanks, > Charles > > > -- > To unsubscribe from this list: send the line "unsubscribe stgt" in > the body of a message to majordomo at vger.kernel.org > More majordomo info at http://vger.kernel.org/majordomo-info.html > -- To unsubscribe from this list: send the line "unsubscribe stgt" in the body of a message to majordomo at vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html |