[debian-non-standard] USB-Stick not active after flashing

Thomas Ohms sm_debian at lokarabia.ath.cx
Thu Jun 26 20:53:34 CEST 2008


Am Mittwoch, den 25.06.2008, 20:08 +0200 schrieb Tomasz Chmielewski:
> Thomas Ohms schrieb:
> 
> (...)
> 
> > As I said: I would answer "yes" here if at least I could get the
> > firmware on my router as mentioned in the HOWTO.
> > So could we start here?! Means my first problem is: when I try to upload
> > the firmware I always receive a timeout by tftp. How did you configure
> > your local network? What steps have you taken to get the firmware on the
> > router?
> > 
> > Thanks very, very much for your patience and help!
> 
> OK, so you're not even able to upload the firmware? You should write 
> more clearly ;) (or I should read more carefully).
> 
> 1. Power off the device, press the reset button, power on the device, 
> release the reset button
> 2. On of the LEDs should blink
> 3. The device will have the address 192.168.1.1 - can you ping it? 
> Obviously, you need an address in the same network if your computer is 
> connected directly with a cable (IP like 192.168.1.2)
> 4. If you can ping it, you should be able to upload the firmware. I use:

I can ping the router, but not upload anything :(



More information about the debian-non-standard mailing list